If you don't have any questions you're looking for, please contact the customer counseling
16 Total
-
The biggest merit is strong surface. The wearing reinforced component, which has been processed through special treatment, is the raw material of abradant therefore it is not damaged even by relatively large impact.
This has been recognized by the contractor who have experience in construction of other floorings. Installation is easy even with offset on the floor through the suspension-type construction. Maintenance is easier than adhesive type.
Further, it is safe from fire. (certified by disaster prevention institute)
For plywood flooring, international supply of plywood and veneer is not smooth therefore problems can occur in price deviation and supply.
It is not easily stained between wood-grain therefore cleaning is easy.
Plywood needs to be repainted after polishing for several times wood-grain. However, the grain is alive rough therefore stain is accumulated and bacteria is generated and live in the space.
-
The flooring is semi-permanent depending on the usage but the average life will be 10 years.
-
Initially, plywood flooring has been developed by using the leftover pieces after plywood processing therefore small size has been settled and we’re already accustomed to it therefore the shape looks good too. For reference, 75×900mm is the most common size. In case of laminate flooring, the size of plate can be adjusted freely therefore such problem does not occur and construction efficiency is excellent.
The size is 190×1200mm. If this is applied for solid wood, relatively large pole will be required.
-
1. 일반적으로 청소는 진공청소기로 해주시고, 마른 걸레로 나뭇결을 따라 바닥을 닦아주세요. 2. 스틸울을 사용하여 청소할 경우 바닥 표면이 손상될 수 있으므로 사용하지 마십시오. 삼. 표면은 항균 처리 및 특수 코팅 처리되어 있으므로 왁스, 윤활 바니시를 사용하지 마십시오. 4. 카펫이나 담요를 바닥에 너무 오래 깔면 바닥이 변형되어 갈라질 수 있으므로 치워두고 주기적으로 환기를 시켜주세요. 5. 싱크대, 변기 입구 등 습기가 많은 곳은 바닥에 발매트(천)를 깔고 수시로 환기 및 건조시켜 주십시오. -
All raw materials are not imported but produced in domestic factory therefore the inventory is maintained at an appropriate level all the time therefore the required amount can be supplied to the place requested by our customers all the time. In case of imported laminated flooring and plywood flooring, the majority of them are imported therefore it is difficult for the company to maintain the inventory. If too much inventory is secured, the problems of fund and warehousing occur therefore the inventory is maintained at small level.
In case of inventory shortage, it will take months even if order is made therefore no customers will accept such situation. -
Stickiness can occur if humidity is too high.
The wood flooring has excellent moisture control performance. Therefore, if the air humidity is high, the wood absorbs it and the humidity decreases.
However, if humidity is too high, wood cannot absorb moisture any longer therefore the flooring can become little bit sticky.
In case of the house with air conditioner or wood materials, which can control humidity, humidity can be lower than other general houses even with the same humidity therefore the flooring can be less sticky.
-
Not at all. The resin used on flooring is the raw material which is used for baby’s cup.
-
* Clean up any spills straight away.
* If moisture stays on the joint part of plank for a long time, deformation can occur but problems do not occur if the moisture is not too much.
However, if pipe explodes or water leaks constantly, defect can occur and such a situation causes problem in any type of flooring.
* In general, use vacuum cleaner to clean dust and wipe with rag with little moisture.
* It is recommended to use fabric foot mat in the damp spaces including kitchen and toilet entrance.
-
* Too high floor temperature can cause fatal problem on laminate flooring.
The nighttime boiler must maintain the heating from nighttime until the next day therefore the temperature can increase to 60℃.
Laminate flooring is made of natural wood material and if it is exposed to high temperature over 35℃ for a long time, excessive contraction, distortion and deformation on joint part can occur due to the characteristics of natural wood material.
In case of electric film, the aforementioned phenomenon can occur due to the high temperature caused by heat line as the nighttime boiler.
Further, the temperature can increase intensively on certain part of the electric film, fatal problem can occur on the laminate flooring.
If installed on electric film, mortar (4cm or over) needs to be put on the film or separate plate (mineral material 6t or over) needs to be installed then the laminate flooring needs to be installed.
If installation is conducted without complying with the aforementioned standard specification, contract and agreement need to be prepared with the client company according to this agenda.
An agreement that the client company will be responsible for the defects in the future needs to be prepared in advance before installation.
-
* The surface of laminate flooring is coated therefore surface coating including separate varnish and wax is not required.
If the laminate flooring surface is coated, it looks good for several days but the strength of the wax coating agent remaining on the surface is too weak. Therefore, the coating layer is damaged easily when object moves on the floor therefore the surface gets dirty. Further, varnish cannot be removed by using oil-based agent therefore restoration is difficult.