If you don't have any questions you're looking for, please contact the customer counseling
10 Total
-
1. 일반적으로 청소는 진공청소기로 해주시고, 마른 걸레로 나뭇결을 따라 바닥을 닦아주세요. 2. 스틸울을 사용하여 청소할 경우 바닥 표면이 손상될 수 있으므로 사용하지 마십시오. 삼. 표면은 항균 처리 및 특수 코팅 처리되어 있으므로 왁스, 윤활 바니시를 사용하지 마십시오. 4. 카펫이나 담요를 바닥에 너무 오래 깔면 바닥이 변형되어 갈라질 수 있으므로 치워두고 주기적으로 환기를 시켜주세요. 5. 싱크대, 변기 입구 등 습기가 많은 곳은 바닥에 발매트(천)를 깔고 수시로 환기 및 건조시켜 주십시오. -
* Clean up any spills straight away.
* If moisture stays on the joint part of plank for a long time, deformation can occur but problems do not occur if the moisture is not too much.
However, if pipe explodes or water leaks constantly, defect can occur and such a situation causes problem in any type of flooring.
* In general, use vacuum cleaner to clean dust and wipe with rag with little moisture.
* It is recommended to use fabric foot mat in the damp spaces including kitchen and toilet entrance.
-
* Too high floor temperature can cause fatal problem on laminate flooring.
The nighttime boiler must maintain the heating from nighttime until the next day therefore the temperature can increase to 60℃.
Laminate flooring is made of natural wood material and if it is exposed to high temperature over 35℃ for a long time, excessive contraction, distortion and deformation on joint part can occur due to the characteristics of natural wood material.
In case of electric film, the aforementioned phenomenon can occur due to the high temperature caused by heat line as the nighttime boiler.
Further, the temperature can increase intensively on certain part of the electric film, fatal problem can occur on the laminate flooring.
If installed on electric film, mortar (4cm or over) needs to be put on the film or separate plate (mineral material 6t or over) needs to be installed then the laminate flooring needs to be installed.
If installation is conducted without complying with the aforementioned standard specification, contract and agreement need to be prepared with the client company according to this agenda.
An agreement that the client company will be responsible for the defects in the future needs to be prepared in advance before installation.
-
* The surface of laminate flooring is coated therefore surface coating including separate varnish and wax is not required.
If the laminate flooring surface is coated, it looks good for several days but the strength of the wax coating agent remaining on the surface is too weak. Therefore, the coating layer is damaged easily when object moves on the floor therefore the surface gets dirty. Further, varnish cannot be removed by using oil-based agent therefore restoration is difficult.
-
Use neutral detergent and wipe lightly to clean and finish with dry rag.
* Do not use oxidated bleaching agent
-
Avoid direct sun-light and block with curtain and blind as much as possible.
-
The flooring surface can be slippery and the user must be very careful.
-
Do not leave it for a long time but wipe it with dry rage before water is absorbed.
-
If carpet is used on living room, ventilate air constantly to prevent concentration of heat under carpet.
-
The noise from laminate flooring is caused by various reasons including irregular subfloor horizontality, foreign substance and air moisture. In general, the high temperature and humidity during the rainy season cause expansion on the joint part of the flooring and this cause rustling sound.
It is important to ventilate inside house constantly and maintain indoor moisture at 50~60% to reduce the noise. Accordingly, if the moisture in your house is high during summer, turn on heating system to reduce the moisture and the noise will decrease a lot.